All Issue

2019 Vol.18, Issue 4 Preview Page

Research Article

A Study on Unconfined Compressive Strength of CLSM with Paper Sludge Ash

제지애쉬가 적용된 CLSM의 일축압축강도 특성에 관한 연구

Jeong-Jun Park1
,
In-Hwan Lee2
,
Eun-Chul Shin3
,
Gigwon Hong4*
박 정준1
,
이 인환2
,
신 은철3
,
홍 기권4*
1Member, Principal Researcher, Incheon Disaster Prevention Research Center, Incheon National University, 119 Academy-ro, Yeonsu-gu, Incheon 22012, Republic of Korea
2Student Member, Graduate student, Department of Civil and Environmental Engineering, Incheon National University, 119 Academy-ro, Yeonsu-gu, Incheon 22012, Republic of Korea
3Member, Professor, Department of Civil and Environmental Engineering, Incheon National University, 119 Academy-ro, Yeonsu-gu, Incheon 22012, Republic of Korea
4Member, Director, Institute of Technology Research and Development, Korea Engineering & Construction, 3-16 Jungdae-ro 25-gil, Songpa-gu, Seoul 05661, Republic of Korea
* Corresponding Author
30 December 2019. pp. 253-262
PDF XML Citation
Abstract

본 연구에서는 하수관 손상을 예방할 수 있는 CLSM을 개발하기 위하여, 산업폐기물인 제지애쉬를 이용한 CLSM의 일축압축강도 특성을 평가하였다. 이를 위해, 각각의 CLSM 배합조건에 따른 유동성시험 및 일축압축강도시험을 수행하였다. 먼저, 유동성시험 결과, 배합조건에 따라 유동성 기준을 만족하는 함수비의 범위는 24%～32%인 것으로 나타났다. 일축압축강도시험 결과, 강도는 재령일 1일에서 7일 사이에 높은 강도증가율을 보였으며, 이때 강도의 크기는 재령일 28일을 기준으로 발현된 전체 강도의 약 50% 이상인 것으로 확인되었다. 그리고 CLSM의 강도 증가는 플라이애쉬의 영향을 크게 받는 것으로 나타났지만, 개발하고자 하는 CLSM의 기준강도를 고려하면 제지애쉬의 배합이 요구되는 것으로 분석되었다. 또한 높은 시멘트 비율을 적용한 경우의 강도가 낮은 경우에 비하여 크게 발현되었지만, 기준강도를 고려하면 시멘트의 비율을 5%로 적용하는 것이 합리적인 배합조건이라고 판단되었다.

This paper described the evaluation results on unconfined compressive strength characteristics of CLSM with paper sludge ash, in order to develop a CLSM that can prevent sewer pipe damage. The flowability test and the unconfined compressive strength test were performed according to mix design condition of CLSM. The flowability test result showed that the water content, which can satisfy the flowability criteria, was 24% to 32% according to the mix design condition. The results of unconfined compressive strength test showed that the strength incremental ratio was high between 1 and 7 days of curing time, and the strength at this time was more than about 50% of the strength at 28 days of curing time. The strength of CLSM was greatly influenced by fly ash. However, it was analyzed that the mixture of paper sludge ash is required when the reference strength of CLSM is considered. Although the strength of the high cement ratio was higher than that of the low cement, a cement ratio of 5% would be a reasonable mix design condition of CLSM.

Keywords
Paper sludge ash
Fly ash
CLSM
Unconfined compressive strength
Backfill material

References
1
ACI (2005), Controlled low strength materials, ACI 229R-99, ACI(American Concrete Institution).
2
ASTM D4832 (2002), Standard test for preparation and testing of controlled low strength material (CLSM) test cylinders.
3
ASTM D6103 (2004), Standard test method for flow consistency of controlled low strength material (CLSM).
4
Bae, Y. S., Kim, K. T. and Lee, S. Y. (2017), “The Road Subsidence Status and Safety Improvement Plans”, Journal of the Korea Academia-Industrial cooperation Society, Vol.18, No.1, pp.545-552.
10.5762/KAIS.2017.18.1.545
5
Cho, D. H., Han, S. J., Kim, J. Y. and Kim, S. S. (2007), “A experimented study on the estimation of optimum mixing ratio and the behavior for backfill by the flowable material using surplus soil”, Journal of the Korean Society of Civil Engineers, Vol.27, No.3, pp.175-184.
6
Crouch, L. K., Gamble, R., Brogdon, J. F. and Tucker, C. J. (1998), “Use of High-Fines Limestone Screenings as Aggregate for Controlled Low-Strength Material (CLSM)”, in The Design and Application of Controlled Low-Strength Materials (Flowable Fill), ASTM STP 1331, A. K. Howard and J. L. Hitch (Eds.). American Society for Testing and Materials (ASTM), West Conshohocken, PA, pp.45-59.
10.1520/STP13061S
7
Emery, J. and Johnston, T. (1986), “Unshrinkable fill for utility cut restorations”, American Concrete Institute, special publication, pp.93-10.
8
Heo, Y., Lee, C. K., Lee, M. W. and Ahn K. K. (1999), “A Study on Utilization Method of Paper Ash in Industrial Waste”, Journal of the Korean Society of Safety, Vol.14, No.4, pp.135-141.
9
Kong, J. Y., Kang, H. N. and Chun, B. S. (2010), “Unconfined compressive strength and flow in controlled low strength materials made with coal ash”, Journal of the Korean Geo- Environmental Society, Vol.26, No.1, pp.75-83.
10
Lee, C. K., Ahn, K. K. and Heo, Y. (2003), “Development of the Bricks using Paper Ash”, Journal of the Korean Geoenvironmental Society, Vol.4, No.2, pp.47-56.
11
Lee, D. Y., Kim, D. M., Ryu, Y. S. and Han, J. G. (2015), “Development and Application of Backfill Material for Reducing Ground Subsidence”, Journal of Korean Geosynthetics Society, Vol.14, No.4, pp.147-158.
10.12814/jkgss.2015.14.4.147
12
Lee, K. H., Kim, J. D., Hyun, S. C., Song, Y. S. and Lee, B. S. (2007), “Deformation behavior of underground pipe with controlled low strength materials with marine dredged soil”, Journal of the Korea Society of Hazard Mitigation, Vol.7, No.5, pp.129-137.
13
NRMCA (1995), Guide Specification for Controlled :Low Strength Materials (CLSM), National Ready Mixed Concrete Association, pp.5-7.
14
Ryu, Y. S., Han, J. G., Chae, W. R., Koo, J. S. and Lee, D. Y. (2015), “Development of Rapid Hardening Backfill Material for Reducing Ground Subsidence”, Journal of Korean Geosynthetics Society, Vol.14, No.3, pp.13-20.
10.12814/jkgss.2015.14.3.013
15
Seo, D. W., Kim, H. Y., Kim, K. M. and Chun, B. S. (2010), “Characteristics of plasticizer lightweight foamed concrete according to changes of mixing ratio”, Journal of the Korean Geo-Environmental Society, Vol.11, No.4, pp.33-42.
16
Seo, S. K. (2017), A study on the Physicochemical Activation of Paper Sludge Ash & Fly Ash and their applications for cement admixture, Ph.D. Thesis, Hanyang University.
17
Won, H. (2010), A Laboratory Study on Anti-acid Mortar using Calcium-Aluminate Cement and Blast-Furnace Slag with Fly-ash, Master thesis, Seoul National University of Technology.
18
Won, J. P. and Lee, Y. S. (2001), “Properties of controlled lowstrength material containing bottom ash”, Journal of the Korea Concrete Institute, Vol.13, No.3, pp.294-300.
Information
  • Publisher :Korean Geosythetics Society
  • Publisher(Ko) :한국지반신소재학회
  • Journal Title :Journal of the Korean Geosynthetics Society
  • Journal Title(Ko) :한국지반신소재학회 논문집
  • Volume : 18
  • No :4
  • Pages :253-262
  • Received Date : 2019-11-30
  • Revised Date : 2019-12-20
  • Accepted Date : 2019-12-20
  • DOI :https://doi.org/10.12814/jkgss.2019.18.4.253
Journal Informaiton Journal of the Korean Geosynthetics Society Journal of the Korean Geosynthetics Society
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close