All Issue

2018 Vol.17, Issue 1 Preview Page
A Study on Estimation of Degree of Compaction by Correction for Coarse Particle Ratio of Fill Material

성토재료의 조립자율 보정에 의한 다짐도 평가에 관한 연구

Jae-Won Yoo1
,
Jong-Chul Im2*
,
Min-Su Seo3
,
Chang-Young Kim4
,
Sang-Kyun Kang5
유 재원1
,
임 종철2*
,
서 민수3
,
김 창영4
,
강 상균5
1Researcher, Research Institute of Industrial Technology, Pusan National Univ.
2Professor, Department of Civil and Environmental Engineering, Pusan National Univ.
3Researcher, Research Institute of Industrial Technology, Pusan National Univ.
4Researcher, Research Institute of Industrial Technology, Pusan National Univ.
5Graduate Student, Department of Civil and Environmental Engineering, Pusan National Univ.
*교신저자. *Corresponding Author. 
30 March 2018. pp. 65-74
PDF XML Citation
Abstract

The degree of compaction of embankments is generally measured using the sand replacement method or a soil density gauge. However, these methods include coarse particles, which are relatively large. The degree of compaction is overestimated if the in-situ soil density is simply compared with the density obtained from a Proctor compaction test (KS F 2312, 2001), because the density of coarse particles is higher than that of soil. However, there is no recommended correction for the coarse particle ratio in Korea, thus intentionally increasing the degree of compaction for structures to which large loads are applied or for which compaction is critical. Here, a correction considering the Korean Proctor compaction test and the difference between the maximum allowable particle sizes was recommended after corrections for coarse particle ratios in other countries were collected and analyzed. The degree of compaction was re-estimated by applying the recommended correction to the results of both Proctor compaction and sand replacement tests. The degree of compaction without the correction of coarse particle ratio was overestimated, because the re-estimated degree of compaction decreased as the coarse particle ratio increased. The relatively accurate results obtained from the field application of the correction will offer long-term cost savings due to reduced maintenance fees during operation.

Keywords
Degree of compaction
Soil density
Coarse particle
Proctor compaction test
Maximum allowable particle size
Fill material

현장에서 일반적으로 성토체의 다짐도 판정을 위해 사용되는 방법으로 들밀도시험이나 밀도계에 의한 측정 등이 사용되는데 이 방법들을 적용시 성토재료에 입경의 크기가 비교적 큰 조립자가 일정량 포함되어 있다. 조립자는 밀도가 흙 보다 높기 때문에 조립자를 고려하지 않고 현장에서 측정한 밀도를 실내다짐시험(KS F 2312, 2001)에서 얻은 최대건조밀도와 비교하여 다짐도 만족 여부를 판단하게 되면 다짐도는 과대평가 된다. 하지만 현재 우리나라 규정에는 조립자율에 따른 보정 방법이 명확하게 제시되어 있지 않아 큰 하중이 작용하거나 다짐이 매우 중요한 구조물 등에서는 다짐도의 기준을 더 크게 적용하고 있다. 따라서 본 연구에서는 국외의 여러 가지 조립자 보정 방법을 종합하고 분석하여 우리나라의 실내다짐시험 방법, 허용최대입경 차이 등을 고려하여 적용 할 수 있는 방법을 제안하였고, 제안된 방법에 의해 실내다짐시험과 현장에서의 들밀도시험을 수행하고 다짐도를 재평가 하였다. 그 결과 제안된 조립자 보정 방법에 의해 재산정된 다짐도는 조립자율이 높을수록 감소하여 조립자 보정을 하지 않았을 경우 다짐도는 과대평가되는 것으로 분석되었고, 조립자 보정을 통해서 산정된 다짐도를 실제 현장에 적용 할 경우, 추후 유지･보수 측면에서 더 효율적인 것으로 판단된다.

References
1
AASHTO T99 (2015). Standard Method of Test for Moisture-Density Relations of Soils Using a 2.5-kg (5.5-lb) Rammer and a 305-mm (12-in.) Drop, American Association of State Highway and Transportation Officials (AASHTO), Washington, D. C.
2
AASHTO T180 (2015). Standard Method of Test for Moisture-Density Relations of Soils Using a 4.54-kg (10-lb) Rammer and a 457-mm (18-in.) Drop, American Association of State Highway and Transportation Officials (AASHTO), Washington, D. C.
3
AASHTO T224-01 (2004), Standard Method of Test for Correction for Coarse Particles in the Soil Compaction Test, American Association of State Highway and Transportation Officials (AASHTO), Washington, D. C.
4
Barnes, G. E. (2000), Soil Mechanics–Principles and Practiced, 2nd Ed., Palgrave, p.463.
5
BS 1377-4 (1990), Compaction-related tests, British Standards, The United Kingdom.
6
Ito, M., Ohta, H., Ishiguro, T. and Yonetani, S. (1991), “Pre-compaction Pressure and Strength of Compacted Soils-Gravel Mixture”, Proceedings of the Society of Civil Engineers, No. 439/3-17, pp.27-36. (in Japanese)
7
Japanese Geotechnical Engineering Society (1979), Soil Testing Act, 2nd revised edition, pp.5.1.16-5.1.18. (in Japanese)
8
Jeoung, J. H., Ryu, S. H., Choi, D. T., Park, K. S. and Hwang, S. P. (2016), “The Study of Compaction Characteristics of Cataclasite Fill Material using Large and Standard Com-paction Tests”, The Journal of Engineering Geology, Vol.26, NO.4, pp.439-445.
9
Kim, D. S., Park, S. Y., Song, J. W., Kim, S. I., and Song, J. J. (2009), “A Study on the compaction charac-teristics of crushed rock-soil mixture for railway subgrade” Journal of the Korean Society for Railway, Vol.12, No.2, pp.183-189. (in Korean)
10
KS F 2312 (2001). Test method for soil compaction using a rammer, Korean Standards Association, Seoul, South Korea. (in Korean)
11
KS F 2311 (2001). Test method for soil density by the sand replacement method, Korean Standards Association, Seoul, South Korea. (in Korean)
12
Ministry of Construction and Transportation (1996), Road Design Standard, Ministry of Construction and Transportation, Seoul, South Korea, p.80. (in Korean)
13
Ministry of Land, Infrastructure and Transport (2016), Road construction Design Standard, Korean Road Traffic Association, Seoul, South Korea, pp.4-22. (in Korean)
14
Walker, F. C. and Holtz, W. G. (1951), “Control of Embankment Material by Laboratory Testing,” Proc. ASCE, Vol.77, No.108, pp.1-25.
Information
  • Publisher :Korean Geosythetics Society
  • Publisher(Ko) :한국지반신소재학회
  • Journal Title :Journal of the Korean Geosynthetics Society
  • Journal Title(Ko) :한국지반신소재학회 논문집
  • Volume : 17
  • No :1
  • Pages :65-74
  • Received Date : 2018-01-22
  • Revised Date : 2018-03-04
  • Accepted Date : 2018-03-07
  • DOI :https://doi.org/10.12814/jkgss.2018.17.1.065
Journal Informaiton Journal of the Korean Geosynthetics Society Journal of the Korean Geosynthetics Society
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close