Evaluation of the Applicability of Inorganic Binders Using Industrial Byproducts as Soil Nailing Grouting Materials

Kwang-Wu Lee; Jae-Hyun Park; Jae-Hyeung Jeoung; Se-Gwan Seo; Kyung-Nam Kang

doi:10.12814/jkgss.2024.23.4.079

All Issue

2024 Vol.23, Issue 4 Preview Page Next Page

Research Article

Evaluation of the Applicability of Inorganic Binders Using Industrial Byproducts as Soil Nailing Grouting Materials 산업부산물 활용 무기결합재의 쏘일네일링 그라우팅 재료 적용성 평가

31 December 2024. pp. 79-87

PDF XML

Abstract

As the demand for carbon neutrality and eco-friendly technologies has increased recently, Korea is also experiencing a high demand for related technologies. In response to these changes in technological demand, this study developed inorganic binders using industrial by-products for soil nailing grouting and evaluated their field applicability. Two types of inorganic binders were developed using SP (slag powder) and HCFA (high-calcium low-quality fly ash). The developed inorganic binders replaced 70% of cement with industrial by-products, and both two types were found to have a 28-day compressive strength in excess of the standard strength of 24MPa, showing their potential for use as grouting materials. Additionally, compressive strength measurements with the use of set accelerators all exceeded the 28-day compressive strength standard. However, it was found that the strength decreased as the used amount of accelerator increased. Based on these results, two field pull-out tests were conducted. Although the grout compressive strengths varied significantly between materials (34.4 ~ 43.8MPa), the average pull-out loads were similar, ranging from 272.33 to 278.21 kN/ea. These results showed the strong potential of the two types of inorganic binders developed in this study for use as soil nailing grouting materials.

Keywords

Fly ash

Low quality high-calcium fly ash

Soil nailing

Grouting

최근 탄소중립 및 친환경 기술요구가 증대됨에 따라 우리나라 또한 관련 기술 수요가 높아지고 있다. 이러한 기술 수요 변화에 따라 본 연구에서는 산업부산물을 활용한 쏘일네일링 그라우팅용 무기결합재를 개발하고 현장 적용성을 평가하였다. SP(슬래그분말) 및 HCFA(고칼슘 저품위 플라이애시)를 사용하여 2종류의 무기결합재를 개발하였다. 개발된 무기결합재는 시멘트의 70%를 산업부산물로 대체하였으며, 두 종류의 무기결합재 모두 재령 28일 압축강도가 기준강도인 24MPa을 초과하는 것으로 나타나, 그라우트 재료로서의 활용 가능성을 확인하였다. 또한 급결제 사용에 따른 압축강도 측정 결과 모두 28일 압축강도 기준을 상회하였으나, 급결제 사용량이 증가할수록 강도가 감소하는 것으로 나타났다. 해당 결과를 바탕으로 2차례 현장 인발시험을 수행한 결과, 배합시험에 따른 압축강도는 재료에 따라 상당한 차이(34.4 ~ 43.8MPa)가 발생하였음에도 불구하고, 평균 인발하중은 272.33 ~ 278.21kN/ea로 유사한 결과를 나타내었다. 결론적으로, 일련의 실험연구를 통해 본 연구에서 개발한 2종류의 시멘트 경감형 무기결합재는 쏘일네일링 그라우트재로 활용할 수 있음이 확인되었다.

References

Cho, D.Y., Lee, G.C. and Baek, D.H. (2016), "Plan for Expanding the Recycling and Reuse Status of Coal Ash as Construction Materials", Magazine of RCR, Vol.11, No.3, pp.18-24

Czigler, T., Reiters, S., Schulze, P. and Somers, K. (2020), "Laying the Foundation for Zero-Carbon Cement", Chicago, IL: McKinsey and Company. Available online at: https://www.mckinsey.com/industries/chemicals/our-insights/laying-the-foundation-for-zero-carbon-cement (accessed March 25, 2021)

Kim, G. W., Kim, B. J., Yang, K. H. and Song, J. K. (2012), "Strength development of blended sodium alkali-activated ground granulated blast-furnace slag (GGBS) mortar", Journal of the Korea Concrete Institute, Vol.24, No.2, pp.137-145.

10.4334/JKCI.2012.24.2.137

Kim, T. W. (2012), "The Strength Properties of Alkali-Activated Slag Mortars by Combined Caustic Alkali with Sodium Carbonate as Activator", Journal of the Korea Concrete Institute, Vol.24, No.6, pp.737-744.

10.4334/JKCI.2012.24.6.745

Kim, Y. S., Moon, D. I. and Lee, D. W. (2011), "An Experimental Study on Alkali-Silica Reaction of Alkali-Activated Ground Granulated Blast Furnace Slag Mortars", Journal of the Korea Institute of Building Construction, Vol.11, No.4, pp.345-352.

10.5345/JKIBC.2011.11.4.345

Ko, H. W., Seo, S. G., An, Y. J., Kim, Y. S. and Cho, D. S. (2016), "Applicability Evaluation of Eco-Friendly Binder Material using Desulfurized Dust in Deep Cement Mixing Method", Journal of the Korean Geosynthetics Society, Vol.15, No.2, pp.1-12.

10.12814/jkgss.2016.15.2.001

KS L 5201 (2021). Portland cement, Korean Standards Association, Seoul, South Korea. (in Korean)

KS L 5405 (2023). Fly ash, Korean Standards Association, Seoul, South Korea. (in Korean)

Lee, K. W., Park, J. H., Seo, S. G. and Kang, K. N. (2024), "A Study on the Engineering Properties and Field Applicability of Inorganic Binder with Industrial by-Products", Journal of the Korean Geosynthetics Society (In press)

LH (2018), "Construction work smart handbook : Civil engineering", Korea Land & Housing Corporation Construction Management Office, pp.309-311.

Park, S. S., Kang, H. Y., and Han, K. S. (2007), "Development of Fly Ash/slag Cement Using Alkali-activated Reaction (1)-Compressive strength and acid corrosion resistance", Journal of Korean Society of Environmental Engineers, Vol.29, No.7, pp.801-809.

Seo, S. G., Song, S. H. and Cho, D. S. (2021), "Analysis of the Applicability of Ground Stabilizer Using Recycled Resources as Prebored Piles", Journal of the Korean Recycled Construction Resources Institute, Vol.9, No.3, pp.287-294.

Sim, J. I. and Yang, K. H. (2010), "Practical Application of GGBS-Based Alkali-Activated Binder to Secondary Products of Concrete", Journal of the Korea Institute of Building Construction, Vol.10, No.5, pp.37-44.

10.5345/JKIC.2010.10.5.037

Information

Publisher :Korean Geosythetics Society
Publisher(Ko) :한국지반신소재학회
Journal Title :Journal of the Korean Geosynthetics Society
Journal Title(Ko) :한국지반신소재학회 논문집
Volume : 23
No :4
Pages :79-87
Received Date : 2024-12-06
Revised Date : 2024-12-18
Accepted Date : 2024-12-19
DOI :https://doi.org/10.12814/jkgss.2024.23.4.079

Journal of the Korean Geosynthetics Society ISSN:2508-2876(Print) 2287-9528(Online) 한국지반신소재학회 논문집

All Issue